Emulex LP9802DC Manual de usuario descargar pdf (Pagina 61)

lpfcN: 42 : Xmit sequence completion error

A XMIT_SEQUENCE command completed with a status error in the IOCB. The

IOCB status, the IOCB IOTAG, the IOCB parameter error, as well as the PortID

this command was directed to are recorded. The driver attempts to recover by

creating a new exchange to the remote device.

ACTION: If there are many errors on one device, check the physical connections to

the Fibre Channel network and the state of the remote PortID.

WARNING IP verbose fcxmitb.c

lpfcN: 43 : Stray CreateXRI completion

Received a CREATE_XRI command completion without issuing a corresponding

CREATE_XRI command (based on the IOTAG field in the CREATE_XRI_CR

IOCB). The IOCB command and IOTAG used to match are recorded.

ACTION: This error could indicate a software driver or firmware problem. If the

problems persist, report these errors to technical support.

ERROR always fcxmitb.c

lpfcN: 44 : Adapter failed to initialize

The host adapter failed to initialize properly. The status register is recorded.

ACTION: This error usually indicates a hardware problem with the adapter, run

diagnostics.

ERROR always lp6000.c

Emulex Documentation, Drivers, and Software

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 67 68 69

Sin comentarios

Emulex LP9802DC Manual de usuario Pagina 61