Emulex OneConnect OCe14000-Series Manual de usuario descargar pdf (Pagina 20)

20 CONNECT | VMware vSphere 5.5 VXLAN Networking and Emulex OneConnect® OCe14000 Ethernet Adapters

CONNECT  DEPLOYMENT GUIDE

12. Login to the vShield Manager Appliance using the following default credentials:

13. Type enable, re-enter the default password.

14. During the initial setup, you will have to log out of the vShield Manager Appliance and log back in before you can proceed with setup.

You will have to allow time for the vShield Manager to complete initializing.

15. Once you log back into vShield Manager, type enable and enter your Password. Type Setup to conﬁgure IP address, subnet mask,

gateway, primary and secondary DNS. If available, enter your DNS domain search list. If no DNS domain list is available, only fully

qualiﬁed hostnames will be resolved. Refer to ﬁgure 18 below.

16. Select “y” to save the new conﬁguration. Logout and login back again to complete setup.

Figure 18. Conﬁguring vShield Manager virtual appliance.

17. Open an internet browser and enter the vShield Manager Appliance URL/IP address you conﬁgured above. Login into the vShield

Manager Appliance using the same default credentials: Login: admin, Password: default.

18. From Settings & Report folder located on left pane, click Conﬁguration tab to conﬁgure Lookup Service URL, vCenter Server IP

address, DNS servers IP address, NTP server and Syslog Server IP addresses. An example is illustrated in ﬁgure 20 below.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Sin comentarios

Emulex OneConnect OCe14000-Series Manual de usuario Pagina 20