Emulex LightPulse LPe1105-M4 HBA Guía de instalación descargar pdf (Pagina 24)

EMC Host Connectivity with Emulex FC HBAs and FCoE CNAs for the Linux Environment

Installation Steps

Installing the adapter

This section contains the following information needed for installing

the adapter:

◆ “Prerequisites” on page 24

◆ “Installation procedure” on page 24

◆ “Matching the adapter with the correct PCI slot” on page 26

Prerequisites

Before the Emulex HBA is installed, the host must be configured with

Linux. Install the Linux kernel (including sources) from the

distribution installation CD, following the procedure provided in the

distribution installation guide. Partition the boot drive and select the

packages and services necessary for the host.

Installation procedure

Follow this procedure to install an adapter in your server.

Note: Newer adapters do not require this first jumper step. Proceed to Step 2.

1. For older adapter models, set the adapter jumpers as shown in

Figure 1to enable it for use with the host.

Figure 1 Jumpers on Emulex adapters

321321

JX1 JX2

LP9002-E

LP9802/DC-E

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 181 182

Sin comentarios

Emulex LightPulse LPe1105-M4 HBA Guía de instalación Pagina 24