Emulex LP10000ExDC Manual de usuario descargar pdf (Pagina 201)

Introduction

Log messages are organized into logical groups based on code functionality within the

Fibre Channel driver. Each group consists of a block of 100 log message numbers. Most

groups require a single block of 100 message numbers, however some groups (INIT, FCP)

require two blocks.

The groups and the associated number ranges are defined in the Message Log table

below. The preamble string shown in the Message Log table is displayed as part of the log

message. The lower case 'x' of the preamble string defines the severity of the log

message. The 'x' will be replaced by one of five lower case letters. Those letters are

defined in the Severity Code table.

Severity Codes

Information and warning messages can be turned ON or OFF by setting/resetting the

appropriate mask bit(s) in the variable 'lpfc_log_verbose' located in the driver configuration

module, lpfc.conf.c. By default, both information and warning messages are disabled.

Configuration error (c), error (e), and panic (p) messages can not be disabled.

Severity Code Table

Code Severity

i Information

w Warning

c Configuration error

e Error

p Panic

Message Group Masks

The following table defines the log message groups and the associated number ranges.

● The preamble string shown in this table is displayed as part of the log message.

● The lower case 'x' of the preamble string defines the severity of the log message

and represents one of five lower case letters defined in the severity codes table.

Emulex Documentation, Drivers and Software

201

1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 365 366

Sin comentarios

Emulex LP10000ExDC Manual de usuario Pagina 201