Emulex LP1005DC-CM2 Manual de usuario descargar pdf (Pagina 102)

Driver for Linux -Troubleshooting Section Page 96

Security Configurator Situations - Access Control Groups (ACGs)

The HBAnyware Security Configurator

(Security Configurator) software package

will not install. An error message states that

the latest version of HBAnyware must be

installed first.

The system either has no HBAnyware software installed or has

an older version of the HBAnyware software installed. In either

case, obtain the latest version of the HBAnyware software and

follow the installation instructions. Remember to install the

HBAnyware software before installing the Security Configurator

package.

Cannot access formerly accessible

serversv via the Security Configurator or

the HBAnyware Utility.

This is actually a symptom of two different problems.

• New Keys Were Generated While Servers Were Offline

• Security Removed While Servers Were Offline

See Table 8 on page 100 for details regarding these

problems.

Cannot run the Security Configurator on a

system that is configured for only secure

access. I cannot run the Security

Configurator on a system that is configured

for only secure server access (it has no client

privileges). The following message is

displayed when the Security Configurator

starts: “This system is not allowed client

access to remote servers. This program will

exit.”

You cannot run the Security Configurator on a system that is

configured for only secure server access. Click OK to close the

message and the Configurator stops.

Table 4: Access Control Groups Situations

Situation Resolution

All servers are not displayed. When I run

the Security Configurator on the Master

Security Client ( MSC), I do not see all of the

systems in available servers or ACG Servers

lists. When I run the Security Configurator on

a non-MSC, I do not see all of the systems I

should see in the ACG Servers list.

Make sure all of the systems are connected to the Fibre

Channel network and are online when you start the

Configurator. Discovery of the systems is done only once, at

startup. Unlike the HBAnyware utility, there is no Rediscover

Devices button. Therefore, the Security Configurator must be

restarted to rediscover new systems.

Cannot add or remove a server. The

Security Configurator shows only a list of the

systems in this system's ACG. I cannot add or

remove systems from the ACG.

This is normal. You can modify the ACG for your system only

on the MSC or on a parent client system.

HBAnyware Utility shows non-ACG

Servers. The HBAnyware utility shows

servers that are part of the ACG and that are

not part of the ACG.

The HBAnyware Utility discovers unsecured servers as well

as servers that are part of its ACG. The servers that you see

that are not part of the ACG are unsecured. They will be

discovered by any system running the HBAnyware Utility on

the same Fibre Channel fabric.

Table 3: General Situations (Continued)

Situation Resolution

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 161 162

Comentarios a estos manuales

Sin comentarios

Emulex LP1005DC-CM2 Manual de usuario Pagina 102

Comentarios a estos manuales

Relacionado con productos y manuales para Software Emulex LP1005DC-CM2