Emulex LP1005DC-CM2 Manual de usuario descargar pdf (Pagina 80)

Driver for Linux - Configuration Section Page 74

ACG Icons

Depending on the configured security topology, a system can be a server in one or more ACGs. It can

also be a client to an ACG. The following icons indicate the state of each of the systems in the Access

Control Group Servers list.

The system is a secure server in the ACG. It does not belong to an Access Sub-Group(ASG).

You can remove this system from the ACG.

The system is a secure server in the ACG and belongs to one or more ASGs. You can

remove this system from the ACG.

The system is a secure server in the ACG and a client to an ASG. You cannot remove this

system from the ACG until you remove it as a client from the ASG.

The system is a secure server in the ACG, a secure server in one or more ASGs and a client

to an ASG You cannot remove this system from the ACG until you remove it as a client from

the ASGs.

The system is a Backup Master. You cannot remove this system from the ACG until you

remove it as a Backup Master.

Create the ACG

When the HBAnyware Security software is installed on a system and the HBAnyware Security

Configurator is run for the first time, that system becomes the Master Security Client (MSC). All of the

available servers are discovered and available to become part of the system Access Control Group

(ACG). You select the systems to be added to the ACG, and the security configuration is updated on all

of the selected servers as well as on the initital system. This selection constitutes the participating

platforms in this security installation.

To create the ACG:

1. Start the HBAnyware Security Configurator for the first time in an unsecure environment. The

computer from which you run the Configurator will become the MSC. The following message is

displayed:

Figure 38: HBAnyware Security Configurator message

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 161 162

Sin comentarios

Emulex LP1005DC-CM2 Manual de usuario Pagina 80