Emulex LP1005DC-CM2 Manual de usuario descargar pdf (Pagina 21)

Driver for Linux - Configuration Section Page 15

Start HBAnyware in Local Element Manager Mode

The HBAnyware utility can also be launched with a command line call for Linux systems.

To launch the HBAnyware utility from the command line:

1. Type "HBAnyware" and press <ENTER>. This starts HBAnyware running in in-band access. You

can also start the utility running in out-of-band access by adding an argument in the form

"h=<host>". The <host> argument may be either the IP address of the host or its system name.

The call will use a default IP port of 23333, but you can override this by optionally appending a

colon (:) and the IP port.

Examples of Modifications

• HBAnyware h=138.239.82.2

HBAnyware will show HBAs in the host with the IP address 138.239.82.2.

• HBAnyware h=Util01

HBAnyware will show HBAs in the host named Util01.

• HBAnyware h=138.239.82.2:4295

HBAnyware will show HBAs in the host with the IP address 138.239.82.2 using IP Port 4295.

• HBAnyware h=Util01:4295

HBAnyware will show HBAs in the host named Util01 using IP port 4295.

Run this modified command line to launch the HBAnyware utility for a single, remote host in local mode.

Note: Remember that not all HBAs for a specific host may be running in-band.

Therefore, running that host out-of-band may display HBAs that do not

appear when the host is running in-band.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 161 162

Sin comentarios

Emulex LP1005DC-CM2 Manual de usuario Pagina 21