Emulex LP1005DC-CM2 Manual de usuario descargar pdf (Pagina 63)

Driver for Linux - Configuration Section Page 57

4. Click the Host Driver Parameters tab. The Installed Driver Types drop-down box displays a list

of all driver types and driver versions that are installed on the adapters in the host. Click the

driver for which you want to make changes.

Figure 29: The HBAnyware Host Driver Parameters Tab

Change a Parameter's Value

After you follow the appropriate procedure to display the host or adapter parameter tab, do the following

to change a parameter's value:

1. In the appropriate parameter tab, click the parameter that you want to change. Information about

the parameter appears on the right side of the screen.

2. Change to the new value. Some parameters contain radio buttons to enable or disable a

parameter, others include pull down values and some contain a blank field in which you enter

the new value.

3. If you want the change to be temporary (causing the parameter to revert to its last permanent

setting when the system is rebooted), check the Make change temporary box. This option is

available only for dynamic parameters.

4. If you are making changes to multiple parameters, and you want all the changes to be

temporary, check the Make all changes temporary box. This setting overrides the setting of the

"Make change temporary" box. Only dynamic parameters can be made temporary.

5. To apply your changes, click Apply.

6. For parameters which cannot be changed dynamically (link speed for example), the driver must

be unloaded, recompiled and then reloaded.

Note: The illustration above is an example. The driver parameters you see may be different

depending on the installed driver.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 161 162

Sin comentarios

Emulex LP1005DC-CM2 Manual de usuario Pagina 63