Emulex ONECONNECT OCE10102-F Guía de usuario descargar pdf (Pagina 27)

(2) Select the Converged Network Adapter card to be set (BIOS setting) in the [Select Host Adapter]

window.

The [Fast!UTIL Options] menu appears. Then perform Step 3 through Step 10.

11 Select [Exit Fast!UTIL] and press the [Enter] key.

12 Select [Reboot System] and press the [Enter] key.

Exit Fast!UTIL

Reboot System

Return to Fast!UTIL

The server reboots.

To return to the [Fast!UTIL] menu, select [Return to Fast!UTIL].

2.2.2 Setting Up SAN Boot

Refer to "Server Support Matrix" to check the support status of SAN Boot and refer to the manual of the serv-

er, OS, or the Converged Network Adapter card that is to be used.

When using a logical unit (LUN) of the ETERNUS DX

storage systems as a boot disk, make sure that the LUN

has enough capacity to install the OS.

2.2.3 Setting the Selectable Boot

1 Select [Selectable Boot Settings] from the [Configuration Settings] menu and press the [Enter] key.

2 Set [Selectable Boot] to "Enabled".

3 Select a boot path (ETERNUS DX

port WWN) and boot LUN#.

The boot path and boot LUN# selection window only appears when [Host Adapter BIOS] is "Enabled"

in [SAN Boot].

If [Host Adapter BIOS] is "Disabled", the boot path and boot LUN# selection window does not appear.

Instead, the window shown in Step 4 appears when [Selectable Boot Settings] is selected.

Chapter 2 Setup Procedure for QLogic Converged Network Adapter Cards

2.2 Setting Up the Converged Network Adapter Cards

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

(FCoE) for VMware

ESX

P3AM-4772-10ENZ0

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Sin comentarios

Emulex ONECONNECT OCE10102-F Guía de usuario Pagina 27