Emulex ONECONNECT OCE10102-F Guía de usuario descargar pdf (Pagina 31)

This option cannot be individually applied to each port on the Converged Network Adapter card.

All ports on the target Converged Network Adapter card are configured with the same settings.

4 Reboot VMware ESXi.

# reboot

5 After rebooting VMware ESXi, check the setting values.

# esxcli system module parameters list -m qlnativefc | grep ql2xmaxqdepth

ql2xmaxqdepth int 8 Maximum queue depth to report for target devices.

2.2.5.2 For VMware vSphere 5

1 Record the module name for the Converged Network Adapter card that is loaded into VMware ESXi.

The underlined portion indicates the loaded module name. In the following example, "qla2xxx" is the

module name.

# esxcli system module list | grep qla

qla2xxx true true

Module names may vary depending on the Converged Network Adapter card that is used.

2 Check the default value for the Converged Network Adapter card.

Specify the module name for the Converged Network Adapter card that you recorded in Step 1 and

check the default value.

# esxcli system module parameters list -m qla2xxx | grep ql2xmaxq

ql2xmaxqdepth int Maximum queue depth to report for target devices.

3 Change the setting values of the parameter for the Converged Network Adapter card driver.

Driver parameter Setting value

ql2xmaxqdepth Arbitrary (*1)

(Up to 512 for each FCoE port of the ETERNUS DX)

*1: Recommended value = 512 ¸ (number of FCoE ports that are connected to a single CA port) ¸

number of LUNs

(Round the result down)

Use the value of "8" if the actual result is lower.

Chapter 2 Setup Procedure for QLogic Converged Network Adapter Cards

2.2 Setting Up the Converged Network Adapter Cards

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

(FCoE) for VMware

ESX

P3AM-4772-10ENZ0

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Sin comentarios

Emulex ONECONNECT OCE10102-F Guía de usuario Pagina 31