Emulex 110 Guía de instalación descargar pdf (Pagina 117)

Fibre Channel over Ethernet (FCoE) Converged Network Adapter (CNA) procedures

117

Installation and Configuration

Fibre Channel over Ethernet (FCoE) Converged Network

Adapter (CNA) procedures

This section provides the following information on Fibre Channel

over Ethernet (FCoE) Converged Network Adapters (CNAs):

◆ “Overview” on page 117

◆ “Installing Fibre Channel firmware on an Emulex CNA” on

page 120

◆ “Installing Menlo firmware on an Emulex CNA” on page 126

◆ “Installing or upgrading the driver and utilities on an Emulex

OCe10102-FM CNA” on page 132

◆ “Updating adapter firmware on an Emulex OCe10102-FM CNA”

on page 139

◆ “Configuring Emulex OneConnect FCoE BIOS/boot LUN

settings for OCe10102-FM CNA adapters” on page 146

Overview

FCoE CNAs are similar to Fibre Channel adapters in that they require

drivers in order to function in a Windows server. However, because

of its ability to converge both Fibre Channel and Ethernet traffic over

a single physical link, the adapter will appear to the Windows server

as two different pieces of hardware. When viewing the Windows

Device Manager, you will see both an Emulex Fibre Channel adapter

as well as an Intel 10 Gigabit network adapter available in the system,

as shown in Figure 95 on page 118.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 239 240

Sin comentarios

Emulex 110 Guía de instalación Pagina 117