Emulex 110 Guía de instalación descargar pdf (Pagina 209)

Using the Emulex configuration tool

209

Miscellaneous Planning and Procedures

Figure 161 Timer settings

Repeat steps 2 and 3 for any other installed adapters you need to

configure.

4. Close the configuration tool by selecting Exit on the File menu at

the top of the configuration tool window.

5. Reboot the server for configuration changes to take effect.

For VNX series or CLARiiON configurations in which the array is

running in legacy mode, if the array commonpath parameter is

disabled (set to '0') then you must use the Emulex configuration

tool (ELXCFG.EXE) to re-enable the Report Unknown SCSI

Devices option. Apply the settings if you need to use

Unisphere/Navisphere Agent before and valid LUNs are

assigned to the host. This procedure is unnecessary if valid LUNs

are assigned to the host, or if the array commonpath parameter is

set to '1' (default setting).

MSCS with tape devices

If using MSCS cluttering on the same host to which you have

connected a tape device, EMC recommends enabling Disable reset for

tape devices by selecting the checkbox in the config tool. This will

prevent bus resets from MSCS intended for disk devices to also be

applied to tape devices.

1 2 ... 204 205 206 207 208 209 210 211 212 213 214 ... 239 240

Sin comentarios

Emulex 110 Guía de instalación Pagina 209