Emulex 110 Guía de instalación descargar pdf (Pagina 33)

Booting from the external storage array

Installation and Configuration

Note that each adapter model uses a specific letter designation for

its firmware and BIOS filenames. Be sure check the readme

included with the upgrade package to ensure you have all of

appropriate files before proceeding to the next step.

2. Reboot your Windows host system using a DOS diskette.

3. At the A:\> prompt, insert the diskette that contains the Emulex

BIOS files (created in step 1).

Note: For users upgrading LP7000, LP8000, and LP900X adapters, follow

steps 4 through 13. For LP98XX and later families (including PCI-Express

adapters), refer to “Lp6dutil for LP98XX and later adapter families” on

page 33.

4. At the A:\> prompt, type lp6dutil and press Enter.

The utility performs diagnostic tests on the installed adapter(s).

You may be required to press Enter after each test so the program

can move on to the next. Once the diagnostics are complete, the

main menu appears.

5. Type 5 and press Enter, to select Maintenance.

6. Type 1 and press Enter, to select Upgrade Firmware.

7. Enter the range of adapters to flash; for example: 1-4 (for four

adapters).

8. Enter the Firmware Image filename, including the path. The

firmware image file should be on the same disk as LP6DUTIL.EXE.

Refer to Table 2 on page 31 for the firmware file to use.

9. When prompted, type 1 and press Enter to proceed with the

upgrade for the first controller.

10. When prompted, type 1 and press Enter to reset the adapter after

loading is complete.

11. Repeat steps 8 and 9 for each adapter in the range entered in

step 6.

12. When all adapters are loaded, type 0 and press Enter at the

Maintenance menu to return to the main menu.

13. Type 7 and press Enter at the main menu to exit the flash utility.

Lp6dutil for LP98XX and later adapter families

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 239 240

Sin comentarios

Emulex 110 Guía de instalación Pagina 33