Emulex 110 Guía de instalación descargar pdf (Pagina 219)

Special instructions for CLARiiON CX200-Series

219

Miscellaneous Planning and Procedures

2. To query an adapter, select the adapter number from the BIOS

utility’s main menu (shown in the following example). When you

are querying all adapters, start with the first adapter:

3. A banner similar to the following appears, displaying the port

and node name for this adapter:

Type 2 and press Enter to configure the parameters for the

adapter you selected.

4. The following adapter configuration menu appears:

Type 2 and press Enter to select Change Default ALPA of this

Adapter.

5. Enter a new AL_PA and press Enter.

Note: Adapters connected to the same SP should all have unique

AL_PAs. Select 01 for all adapters on one node, select 02 for all adapters

on the next node, and so on.

Emulex Light Pulse BIOS Utility, xB 1.60A7

Emulex Adapters in this system

1. LP8000: ALPA: 01(NVRAM ALPA: 01) PCI Bus #:02 PCI Device #:04

2. LP8000: ALPA: 01(NVRAM ALPA: 01) PCI Bus #:01 PCI Device #:03

Enter a Selection:

LPx000: I/O Base: 3400 Firmware Version: xS 3.20X4

Port Name: 10000000 C8B0D022 Node Name: 20000000 C8B0D022

Topology: FC-AL

1. Configure Boot Devices

2. Configure This Adapter's Parameters

1. Enable or Disable BIOS

2. Change Default ALPA of this Adapter

3. Change PLOGI Retry Timer <+Advanced Option+>

4. Topology Selection <+Advanced Option+>

5. Enable or Disable Spinup Delay <+Advanced Option+>

6. Auto Scan Setting <+Advanced Option+>

7. Enable or Disable EDD 3.0 <+Advanced Option+>

1 2 ... 214 215 216 217 218 219 220 221 222 223 224 ... 239 240

Sin comentarios

Emulex 110 Guía de instalación Pagina 219