Emulex 110 Guía de instalación descargar pdf (Pagina 175)

Installing Emulex LPSe12002 8 Gb PCIe EmulexSecure Fibre Channel adapter

175

Installation and Configuration

Configuring PowerPath encryption with RKM server

1. Copy the credentials to the host.

Once PowerPath is installed and registered, copy the .cer and .pfx

client credentials files generated by RKM server to the PowerPath

encryption configuration directory C:\Program

Files\EMC\RSA\Rkm_Client\config.

This directory should also contain four client configuration file

templates (.tmpl files) by default.

2. Edit the Key Manager Client Configuration files.

Check the content of the following files:

a. Rkm_init.conf

b. Rkm_keyclass.conf

c. Rkm_registration.conf

d. Rkm_svc.conf

IMPORTANT

Accurate information about the RKM server IP address, client

credentials file path, keyclass, etc., are needed for successful

configuration. Any misconfiguration here may result in failure

starting encryption daemon or turning on device encryption in

a later step.

3. Run the following batch file to kick start the xcrypt configuration

procedure. An example output is shown in Figure 156 on

page 176:

a. C:\Program Files\EMC\RSA\CST\lib\RKM_Config.bat

b. Lockbox passphrase – Teleph0ne# Require certain password

requirements

c. Client Credential ID and Password needed

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 239 240

Sin comentarios

Emulex 110 Guía de instalación Pagina 175